![]() ![]() Setting up for TCP mode / COM port over Ethernet Mind that here I was using 230400 baud rate, however 921800 is recommended. Important Note: While configuring, you always have to press OK button at the bottom, plus Apply Settings in the left hand menu. This mode is used in order to directly transfer data from the Mode-S Beast over the network to Planeplotter.įor Xport use, it is quite essential to use the binary format, so DIP#3 must be ON.īefore doing any other work, you need to set the CPU Performance Mode to High, press OK and then Apply Settings ![]() Note it might be that with some restricted LAN configuration (for example, NAT mode in a virtual machine running windows), these parameters won't show up completly. Lantronix Device Installer can be used to discover and check settings of the Xport ![]() NOTE: Lantronix Device Installer does not work with Xport Edge Note that this setup currently needs to be updated to TCP mode! (All is equal but UDP no longer used as protocol) Lantronix Device Installer
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |